What is perforated embroidery?Hole-carving embroidery, also known as hole-punching embroidery, is to use tools such as hole-carving knives or hole-carving needles installed on the embroidery machine to make holes in the embroidery fabric before embroidering the edge of the bag. This is a kind of embroidery method which is difficult to plate making and equipment, but has a very unique effect.
Its biggest characteristic is to be in embroider making process, need to prick a hole by decorative pattern, and in the hole or side embroider with different method gives a variety of pattern combination, make embroider face have free and easy on-the-spot flower already, have exquisite and beautiful hollow out flower again, so false and true photograph line, rich interest, make embroider article appears decorous, delicate, have a style of one's own.
The embroidery of carving hole embroider makes big machine and peace embroider machine, still new research and development laser machine now, nevertheless the technology is not quite mature, efficiency is very low also, popularization is limited at present!The use of the original machine is also very few, do carved holes or use large machine and embroidery machine, cutting piece embroidery using flat embroidery machine in the majority.
The general big machine punching embroidery effect is good, the hole rules, smooth, clean, no residual yarn in the hole.However, there is a disadvantage that the big machine cannot embroider on the cut piece, so if the cut piece needs punching embroidery, it can only be embroidered by small machine, and our Jiateng embroidery is more outstanding in punching embroidery technology.
Carved hole and embroidered plate:
Embroidery hits version software to have engraving hole function of plate making, do not have special technique, hit flat needle like, the thickness that wants to carve empty place to want according to fabric to do more needle number however, make fabric a hole.If the embroidery machine is used for punching needles, plate making and embroidery needles are the same, do not use the hollow function, directly hit it.
In addition to the normal flat embroidery plate, then use another color to carve the position of the hole, with a single needle, needle pace of about 1.5, first in the edge of the hole to make a circle, and then go inside the hole a meter needle.The position of the carving hole needs how many needles, mainly according to the thickness of the cloth.Thick fabric requires a few more stitches to puncture the fabric.
After finishing the hole position, the third color was used to lay down the flat embroidery part below.Note that in the flat embroidery of the carved hole in the middle of the carved hole package edge to make a single needle, to fix the position of the carved hole, to this carved hole embroidery all procedures have been done, after finishing, adjust the order of embroidery can be used.
Other: if necessary, paper, hot melt film, etc., to strengthen the effect and leveling and three-dimensional sense!